Adjusting the Handle
Position
Refer to
Figure 15
for the different handle positions.
1. Hanging storage/transport position
2. Lower working position
3. Upper working position
Note:
For proper storage procedure, refer to
Preparing the Machine for Storage (page
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the operator-presence
control
(Figure
16).
Important:
When you release the
operator-presence control, the engine
should shut off and the cutting line should stop
within 5 seconds. If they do not stop properly,
stop using your machine immediately and contact
an Authorized Service Dealer.
Figure 15
4. Storage/transport position
5. Service position
17).
12
g017546
Figure 16
g025627
g017546