Product Overview - Toro HoverPro 400 Operator's Manual

Figure 5
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Slowly pour oil into the oil-fill hole, wait 3
minutes, and check the oil level on the dipstick
by wiping the dipstick clean and then inserting,
but not screwing in, the oil-fill cap into the hole
(Figure 6).
g017532
Figure 6
Note:
Fill the engine crankcase with oil until
the dipstick indicates that the engine oil level
is correct as shown in
the engine with oil, remove the excess oil as
directed in Changing the Engine Oil (page
4. Install the dipstick and hand tighten it securely.
Important:
Change the engine oil after the
first 5 operating hours; change it yearly
thereafter. Refer to
(page 15).
g017530
3. The oil level is too
low—add oil to the
crankcase.
Figure 5. If you overfill
15).
Changing the Engine Oil

Product Overview

g017530
1. Handle
2. Operator-presence control
3. Switch box
5
4
g017532
3
2
1. Spark plug
2. Exhaust guard
3. Exhaust
4. Dipstick
5. Finger guard
6. Starter grip
8
Figure 7
4. Handlebar securing knob
5. Footstop
6
1 11
g017377
Figure 8
7. Fuel-cap-vent knob
8. Fuel cap
9. Choke lever
10. Air cleaner
11. Carburetor
g017382
7
8
9
10
g017377