USCutter LaserPoint3 User Manual & Assembly Instructions page 15

Adjust the pinch rollers so there is one roller located
on each side of the vinyl (and, on models with 3
or more rollers, one roller near the center). Avoid
lowering a pinch roller to the gap between the two
feed rollers.
5
Engage the Pinch Rollers by pushing down
on the Pinch Roller Release Levers.
If the cutter is not already on, turn it on now.
4
15
425.481.3555
1
Leave a gap of between
edge of the roller and the edge of the vinyl
on both sides.
6
www.uscutter.com
Setting up Media
1
/ "-1 / " from the
2 2