USCutter LaserPoint3 User Manual & Assembly Instructions page 12

Connecting the cutter to a computer
Attach the power cord to the cutter and then
plug in the unit and turn on the power.
NOTE: Only one connection method (USB or Serial) is needed. USB is recommended.
INSTALLING VINYL MASTER SOFTWARE (If purchased)
Your Vinyl Cutter may have optionally come bundled with VinylMaster Cut
software which is Windows compatible. Software is download only (no CD).
Download VinylMaster Cut software at www.uscutter.com/download
You will need the key code packaged with this cutter to activate the
software. You may need to download drivers to support your operating
system. Drivers are available at http://support.uscutter.com
Training for VinylMaster is all done via short videos accessed through the
software. To access the videos, click on the
then further on HELP TOPICS.
If using the USB Cable to connect your cutter to a computer:
(USB is the recommeded connection method)
In most cases, all needed PC drivers will be preloaded in VinylMaster.
If you need to download and install drivers for the USB connection to
work properly go to www.uscuttersupport.com and select the driver that
supports your Windows version.
If using the Serial Cable to connect your cutter to a computer:
If you are using a Serial Cable to connect your cutter to a computer then
no further setup is necessary. Simply connect one end of the cable to
the cutter and the other end to a computer and setup is complete. If
you have more than one serial connection on your computer or you are
experiencing communication issues between your cutter and computer
then you may wish to verify that the correct COM port is being used in
your software setup, but for most users the COM port will be COM1.
SUPPORT link in VinylMaster,
12
425.481.3555
KEY CODE
www.uscutter.com