Maximum Rinse Level; Suds Cooling; Anti-Crease; Low Water Pressure - Miele WWB 020 Operating Instructions Manual

 Maximum rinse level
The water level in the rinse can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent wash
results. The water consumption will be
increased.
Options
 = Maximum rinse level is
switched off (factory default
setting)
 = Maximum rinse level is
switched on
 Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
Normal program with a temperature of
70°C or higher is selected.
Suds cooling should be activated:
– To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– Where the drainage pipes do not
comply with DIN 1986.
Options
 = Suds cooling is switched off
(factory default setting)
 = Suds cooling is switched on
Programmable functions
 Anti-crease
The Anti-crease function reduces
creasing after the end of the program.
At the end of the program, the drum
continues to turn at intervals for up to
30 min. The door can be opened at any
time during the Anti-crease phase.
Options
 = The Anti-crease function is
switched off
 = The Anti-crease function is
switched on (factory default
setting)
 Low water pressure
If the water pressure is below 100 kPa
(1 bar), the program will be cancelled
and the fault message  will appear.
If the water pressure cannot be
increased, activating this function will
prevent the program from being
cancelled.
Options
 = Low water pressure is
switched off (factory default
setting)
 = Low water pressure is
switched on
75