Selecting Midi Channels; Selecting Presets; Adjusting Volume & Pan Position - E-Mu Planet Phatt Operation Manual

BASIC OPERATION
• • • If Planet Phatt is not
responding properly or plays
the wrong preset, make sure
that both Planet Phatt and
your MIDI controller are set
to the same MIDI channel
and that the MIDI Volume is
turned up.
For more information about
MIDI, see MIDI Realtime
Controls on page 52.
Bank Contents
128 RAM Presets
0
1 128 RAM Presets
2 128 ROM Presets
3 128 ROM Presets
4 128 ROM Presets
••• Channel Pan should
normally be set to "P" unless
realtime control of panning is
desired. This will allow the
programmed pan setting for
each preset to be used.
MIDI CHANNEL SELECTION
Press the cursor key repeatedly untiil the cursor is underneath the
channel number. (The cursor is a little flashing line underneath one of
the parameters in the display.) Rotate the data entry control to select
MIDI channel 01-16. As the channel is changed, the display will
change to show the preset, volume and pan associated with the
displayed channel.
M I D I C ha nne l
P r og ra m No .
PRESET SELECTION
Press the cursor key repeatedly until the cursor is underneath the
program number. (The cursor is a little flashing line underneath one
of the parameters in the display.) As the data entry control is rotated,
the preset number and name will change. The displayed preset will be
assigned to the displayed MIDI channel. Programs are arranged into
banks of 128, as shown in the diagram at left. Banks can be selected
independently of the of the program number by pressing the the
Home/Enter button while turning the data entry knob.
C01 Vol127 Pan=P
000 Preset Name
CHANNEL VOLUME
Press the cursor key repeatedly until the cursor is underneath the
volume value. Rotate the data entry control to select volume 000-127.
(This is the same parameter as MIDI volume control #7, and changes
made over MIDI will be shown in the display.)
CHANNEL PAN
Press the cursor key repeatedly until the cursor is underneath the pan
value. Rotate the data entry control to select pan values -7 to +7 or
"P". When "P" is selected, the pan value specified in the preset is
selected. Any other value will override the pan parameter in the pre-
set. (This is the same parameter as MIDI pan control #10, and changes
made over MIDI will be shown in the display.)
12 Planet Phatt Operation Manual
V olu me
C01 Vol127 Pan=P
0
000 Preset Name
Ban k No .
0
St ereo Posi ti on
Prog ram Nam e
MIDI Channel Parameters
Preset Information