E-Mu Planet Phatt Operation Manual page 122

MIDI SPECIFICATIONS
1st ll mm pair = beat # 0-99
2nd pair = tempo 0-240
3rd pair = X factor -36 to +36
4th pair = preset # 0-639
TRANSMITTED SYSTEM EXCLUSIVE COMMANDS
Command
Preset Data
ll= preset # lsb
Parameter Value
Tuning Table
Program Map Data F0 18 0A dd 07 ... ... F7
Config. Message
Instr. List
Preset List
Set User Beat Data F0 18 0A dd 31 ll mm ll mm ll mm ll mm F7
Set User Song Data F0 18 0A dd 33 ll mm... F7
• Note 1 - Version Request
This command allows identification of machine type and software
revision. Planet Phatt will respond to the request with the version
data: F0 18 0A dd 0B ss r1 r2 r3 F7
r1, r2, r3 = software revision # in ascii (decimal point between r1 & r2).
ss = E-mu module type, 02 = Orbit, 03 = Planet Phatt
• Note 2 - Configuration Message
This MIDI command is used to identify the sound sets in a given
Planet Phatt. The configuration request command is:
F0 18 0A dd 0C F7
Planet Phatt will respond to this command with the configuration
message: F0 18 0A dd 0D pl pm 0D l1 m1 0E l2 m2 F7
where pl and pm are the lsb and msb of the total number of presets, s1
and s2 are the ID numbers of the sound sets contained in this unit,
and n1=l1, m1 and n2=l2, m2 represent the lsb and msb of the num-
ber of instruments in each sound set. If no expansion set is present, s2
will be 7F and n2 will be zero.
Planet Phatt Sound Set IDs = 13 & 14 (0D & 0E - hex)
114 Planet Phatt Operation Manual
Message
F0 18 0A dd 01 ll mm ... ... CS F7
mm = msb cs = checksum
F0 18 0A dd 03 pl pm vl vm F7
F0 18 0A dd 05 ... ... F7
F0 18 0A dd 0D pl pm s1 l1 m1 s2 l2 m2 F7
F0 18 0A dd 0F (14 bytes per instr.) ... F7
F0 18 0A dd 13 (13 bytes per preset) ... F7 see note 4
ll, mm Song Beat # (0-27)
Comments
pl = parameter # lsb pm = msb
vl = value lsb vm = msb
TT data = 256 bytes
see note 8
see note 2
see note 3
80 bytes
see note 11