Preparing The Remote Control; Power On And Setup - Philips NeoPix Easy NPX440 User Manual

Preparing the remote
control
CAUTION!
The improper use of batteries can lead
to overheating, explosion, risk of fire and
injury. Leaking batteries can possibly
damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or charging
the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
• When using the remote control, point
the remote control at the IR sensor on
the projector, and make sure there is no
obstacle between the remote control and
the IR sensor.

Power on and setup

1 Press to turn on the projector. The LED
on the projector turns from red to green.
• To turn off the projector, press
The LED on the projector turns from
green to red.
• The distance between the projector and
the screen determines the actual size of
the image.
Initial operation
2 To adjust the screen height when placing
the projector on the table, turn the angle
adjustment knob located on the bottom of
the projector.
3 To adjust image focus, turn the focus knob
on the top of the projector.
NeoPix
4 To correct keystone or distorted images to
be rectangular or square, turn the keystone
knob on the top of the projector.
NeoPix
Easy
again.
AUX MICRO SD HDMI
Easy
USB DC
9