Advertisement
Operation
Using the Lock
Adding the Administrator (The first 3 users are administrators)
1.
Remove the battery cover, short press 'Set' (back panel) or long press '*' and then a
voice will prompt: 'Please add administrator'.
2. Add the administrator's fingerprint (3 times), card or password (6-8 numbers)
followed by '#' (the same password must be entered again as a confirmation).
3. A voice will say: 'Added successfully'.
4. Then you can continue to add users.
Notes:
1.
Different position fingerprints can be added to improve the fingerprint identification
rate.
2. '*' is used as the back and sign out button, while '#' is used as the confirm button.
Adding a User
An administrator is required to verify and assist in adding another user.
1.
Remove the battery cover, short press 'Set' (back panel) or long press '*' and then a
voice will prompt: 'Please verify the administrator'.
2. Verify the administrator.
3. Add the user's fingerprint (3 times), card or password (6-8 numbers) followed by '#'
(the same password must be entered again as a confirmation).
4. The voice will say: 'Added successfully'.
5. Then you can continue to add users.
Deleting a User
1.
Remove the battery cover, short press 'Set' (back panel) or long press '*' and then a
voice will prompt: 'Please verify the administrator'.
2. Verify the administrator.
3. Short press Set (back panel) or long press '*' again.
4. Press '1' to remove all user fingerprints, press '2' to remove all user passwords, press '3'
to remove all user cards and press '4' to remove all users.
5. The voice will then say: 'Successful'.
Note: The administrator can't be removed by doing this, only normal users.
Modify Password
1.
Press '7' and '#' and you will hear a long beep from the lock.
2. Enter the old password that is to be changed. The lock will prompt "Please add user".
3. Enter the new password followed by '##'. The lock will then prompt "Successful".
Note: The old password that was modified will be invalid after the change.
Reset the Lock
1.
Remove the battery cover, long press 'Set' for 3 seconds and verify the administrator.
2. The system will restore itself to factory default settings.
Notes:
12
Advertisement
