Setting The Time Zone - NETGEAR ProSafe Quad WAN FR538G Reference Manual

ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
To upgrade router software:
1. Select Administration > Settings Backup and Firmware Upgrade from the main menu.
The Settings Backup and Firmware Upgrade screen will display.
2. In the Router Upgrade section, click Browse to locate the saved upgrade file.
3. Locate the downloaded file and click Upload. This will start the software upgrade to your
quad WAN gigabit firewall router. This may take some time. At the conclusion of the upgrade,
your router will reboot.
Warning: Do not try to go online, turn off the router, shutdown the computer or do
4. After the quad WAN gigabit firewall has rebooted, select Monitoring > Router Status to
confirm the new firmware version and to verify that your router now has the new software
installed.
Note: In some cases, such as a major upgrade, it may be necessary to erase the
configuration and manually reconfigure your router after upgrading it. Refer to
the Release Notes included with the software to find out if this is required.

Setting the Time Zone

Date, time and NTP Server designations can be input on the Time Zone screen. Network Time
Protocol (NTP) is a protocol that is used to synchronize computer clock times in a network of
computers Select Administration from the main menu and Time Zone from the submenu. The
Time Zone screen will display.
To set Time, Date and NTP servers:
1. Select Administration > Time Zone from the main menu. The Time Zone screen will display.
2. From the Date/Time pull-down menu, select the Local Time Zone. This is required in order
for scheduling to work correctly. The quad WAN gigabit firewall includes a Real-Time Clock
(RTC), which it uses for scheduling.
3. If supported in your region, check the Automatically Adjust for Daylight Savings Time
radio box.
4. Select a NTP Server option by checking one of the following radio boxes:
5-16
anything else to the router until the router finishes the upgrade! When the
Test light turns off, wait a few more seconds before doing anything.
v1.0, November 2007
Router and Network Management