NETGEAR ProSafe Quad WAN FR538G Reference Manual page 22

ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
Table 1-1. Object Descriptions
Object Activity
On (Green)
1. Power
Off
LED
On (Amber)
Blinking (Amber)
2. Test LED
Off
Four RJ-45 WAN
ports
Link/Act LED
On (Green)
Blinking (Green)
3. WAN
Off
Ports
and
Active LED
LEDs
On (Green)
On (Amber)
Off
4-port RJ-45 10/100/
1000 Mbps Fast
Ethernet Switch
LAN LED
Green (On)
4. LAN
Amber (On)
Ports
Amber (Off) and
and
Green (Blinking or
LEDs
Solid)
Off
DMZ (port 4)
On (Green)
Off
DB9 male connector
5. Console
Port
Push in with a sharp
6. Factory
object
Defaults
1-6
Description
Power is supplied to the firewall.
Power is not supplied to the firewall.
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
N-way automatic speed negotiation, Auto MDI/MDIX.
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port has a valid Internet connection.
The Internet connection is down or not being used because the port
is available for failover in case the connection on other WAN port
fails.
The WAN port is either not enabled or has no link.
N-way automatic speed negotiation, auto MDI/MDIX.
The LAN port is communicating at 1G.
The LAN port is communicating at 100M.
The LAN port is communicating at 10M.
The LAN port has no link.
Port 4 is operating as a dedicated hardware DMZ port
Port 4 is operating as a normal LAN port.
Port for connecting to an optional console terminal. Default baud rate
is 115.2K; pinouts: (2) Tx, (3) Rx, (5) and (7) Gnd.
Factory Defaults reset push button (see
Settings and Technical Specifications"
v1.0, November 2007
Appendix A, "Default
for the factory defaults).
Introduction