Stihl RMI 632 P Instruction Manual page 167

Message:
0185 – Temperature high
see message 0181
Message:
0186 – Temperature low
see message 0180
Message:
0187 – Temperature high
see message 0181
Message:
0302 – Drive motor fault
Temperature range exceeded
Possible cause:
– Temperature in left drive motor too high
Remedy:
– Allow the robotic mower to cool down
Message:
0305 – Drive motor fault
Left wheel is stuck
Possible cause:
– Overload at left drive wheel
Remedy:
– Clean the robotic mower (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0402 – Drive motor fault
Temperature range exceeded
Possible cause:
– Temperature in right drive motor too
high
Remedy:
– Allow the robotic mower to cool down
0478 131 9942 C - EN
Message:
0405 – Drive motor fault
Right wheel is stuck
Possible cause:
– Overload at right drive wheel
Remedy:
– Clean the robotic mower (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0502 – Mowing motor fault
Temperature range exceeded
Possible cause:
– Temperature in mowing motor too high
Remedy:
– Allow the robotic mower to cool down
Message:
0505 – Mowing motor fault
Mowing blade blocked
Possible cause:
– Dirt between carrier plate and mowing
deck housing
– Mowing motor cannot be switched on
– Mowing motor overloaded
16.2)
Remedy:
– Clean mowing blade and mowing deck
( 16.2)
Clean carrier plate (
– Set higher cutting height (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0701 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery too low or too
high
16.2) Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (
Message:
0703 – Battery discharged
see message 0100
Message:
0704 – Battery discharged
see message 0100
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
16.6) Message:
9.6) 1010 – iMow raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by the
hood
Remedy:
– Check movement of the hood and
confirm the message with OK
6.4)
165