Stihl RMI 632 P Instruction Manual page 120

Provide a free wire end (1) with a length of
approx. 2 m.
Route the perimeter wire (2) in front of and
behind the docking station (1) with 50 cm
of clearance and at right angles to the floor
plate. A corridor can then be installed
( 12.11) or the edge of the mowing area
followed with the perimeter wire.
A freely travellable area with a minimum
width of 44 cm must be available to the
side of the floor plate (3).
Further information on installation
of the external docking station is
contained in the "Installation
examples" section. (
118
Wire routing in the mowing area:
Route the perimeter wire (1) around the
mowing area and around any obstacles
( 12.9) and fasten it to the ground using
fixing pins (2). Check the clearances using
the iMow Ruler. (
The robotic mower must not be
more than 35 m from the perimeter
wire at any point, as this would
prevent the wire signal being picked
up.
27.)
12.5)
Avoid routing at acute angles (less than
90°). In acutely angled lawn corners,
fasten the perimeter wire (1) to the ground
with fixing pins (2) as illustrated.
After a 90° corner, at least the length of an
iMow Ruler must be routed in a straight
line before the next corner is installed.
When routing around high obstacles such
as wall corners or high flowerbeds (1), the
wire clearance must be maintained at the
corners to prevent the robotic mower from
scraping against the obstacle. Route the
perimeter wire (2) with the aid of the
iMow Ruler (3) as illustrated.
● If necessary, extend the perimeter wire
using the wire connectors supplied.
( 12.16)
● In the case of several adjacent mowing
areas, install secondary areas
( 12.10) or join the mowing areas with
corridors. ( 12.11)
0478 131 9942 C - EN