Table of Contents
Advertisement
5. Start-up and operation
Warning
• Only operate the product from a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Disconnect the product from the power supply using the
On/Off switch – if this is not available, unplug the power
cord from the socket.
• If using a multi-socket power strip, make sure that the
total power consumption of all connected devices does
not exceed the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged
period, disconnect it from mains power.
Mains operation
Switching on
• Connect the mains lead on the loudspeaker to a properly
installed socket.
The loudspeaker switches on automatically.
Note – switching on for the first time
• When first switched on, the loudspeaker is in "Device
setup" mode and the status LEDs (1–5) pulse.
• If setup mode is not active, briefly press the [SETUP]
button (3) on the back of the device to activate WPS
mode (flashes rapidly). Alternatively, press and hold
the [SETUP] button (3) for around 7 seconds to open
an AccessPoint (flashes slowly).
• At the next switch-on, all of the status LEDs (1–5) flash
orange until the connections made so far have been
restored. Depending on the internet signal strength,
this may take up to 20 seconds.
Battery operation
Warning – rechargeable battery
• Use only suitable chargers to charge the device's battery.
• Do not use defective chargers or USB ports and do not
attempt to repair them.
• Do not store, charge or use the device in extreme
temperatures.
• Charge regularly (at least quarterly) during periods
of prolonged storage.
• The product contains a rechargeable battery.
• Fully charge the product once before using it for the
first time.
• Connect the mains lead on the loudspeaker to a properly
installed socket. The socket must be installed close to the
product and must be easily accessible.
• The loudspeaker switches on automatically.
• During the charging process, the current charge level
is indicated by the status LEDs.
Note – charging process
• A complete charging cycle takes about 3–5 hours.
• The product's battery can be charged both when it is
switched on and off.
• If the battery capacity is less than 30%, a warning
sound is heard once. The status LEDs (1–5) on the
loudspeaker flash red once. This information is only
provided if the product is switched on.
• The actual battery life will vary depending on how you
use the device, the settings and the environmental
conditions (batteries have a limited life).
Battery charge level indicator
• While the power is on, briefly press [POWER] (1) to
display the current battery charge level.
• Refer to the LED table for an explanation of the LED display.
• The LEDs go out after 3 seconds.
Switching on/off / standby
Note
• Please be aware that Amazon Alexa only responds
when the device is on and when it is in standby mode.
Mains operation
• Press [POWER] (1) to switch on the speaker.
• After 10 minutes without playback, the speaker
automatically switches to standby mode.
• Press and hold [POWER] (1) for about 3 seconds to
switch off the speaker.
Note
• To switch off the speaker completely, disconnect it
from the power supply.
Battery operation
• Press [POWER] (1) to switch on the speaker.
• After 10 minutes without playback, the speaker
automatically switches to standby mode.
• After 10 minutes in standby mode, the speaker switches
off.
• Alternatively, press and hold [POWER] (1) for about 3
seconds to switch off the speaker.
2
Advertisement
Table of Contents
