Hama Aqua Jam - Mobile Speaker Manual
![]()
Technical Data
Frequency range: | 20 Hz – 20 kHz |
Output: | 3 W |
Battery type: | 3.7 V / Li-Po / 300 mAh / 1.11 Wh |
Charging voltage: | 5 V 160 mA |
Impedance: | 4 Ω |
Range: | < 10 m |
Bluetooth® technology: | Bluetooth® v3.0, A2DP V1.2, AVRCP V1.0, HFP V1.5, GAVDP1.2, HSP1.2, IOP. |
Controls and Displays
![Hama - Aqua Jam - Controls and Displays Overview Controls and Displays Overview]()
- On/off button
- LED indicator
- Microphone
- Micro-USB connection
- Attachment eyelet for carabiner
Package Contents
- "Aqua Jam" Bluetooth® smartphone speakers
- 1x USB charging cable
- 1x flotation ring
- 1x carabiner
- These operating instructions
Safety Notes
- The product is intended for private, non-commercial use only.
- Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
- Do not use the product in areas where the use of electronic devices is not permitted.
- Since the battery is integrated and cannot be removed, you will need to dispose of the product as a whole. Do this in compliance with the legal requirements.
- Do not drop the product and do not expose it to any major shocks.
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
- Do not open the device or continue to operate it if it becomes damaged.
- Keep the packaging material out of the reach of children due to the risk of suffocation.
- Be considerate. Loud volumes can have a detrimental effect on your surroundings.
- Dispose of packaging material immediately according to locally applicable regulations.
- Do not modify the product in any way. Doing so voids the warranty.
- Keep this product, as all electrical products, out of the reach of children!
- Do not allow yourself to be distracted by the product, for example when driving a vehicle or operating sports equipment. Always pay attention to the surrounding traffic and your environment.
- Do not use the carabiner when climbing, to protect against falling or to secure people or objects.
- Use the flotation ring only for its intended purpose.
Getting Started and Operation
Turning on the product
- Press and hold the on/off button (1) for approx. 4 seconds to turn on the speaker.
- A signal tone confirms that the device is ready for operation. The LED indicator (2) flashes red and green alternately.
Turning off the product
- Press and hold the on/off button (1) for approx. 4 seconds to turn off the speaker.
- A signal tone confirms that the device is turning off. The LED indicator (2) flashes red before going out.
Note – Automatic power off
- Note that the speaker will automatically turn off after 10 minutes without action (no audio playback/no Bluetooth® function). The corresponding signal tone sounds.
Bluetooth® pairing
Note
- Check whether your mobile device (MP3 player, mobile phone, etc.) is Bluetooth® capable.
- The functions described in this section are only available for Bluetooth® -capable terminal devices.
- Note that the maximum range for Bluetooth® is 10 metres without obstacles such as walls, people, etc.
- Make sure that your Bluetooth® -capable terminal device is on and Bluetooth® is activated.
- Make sure that your Bluetooth® -capable terminal device is visible for other Bluetooth® devices.
- Make sure that the speaker is located within the Bluetooth® range of max. 10 metres.
- Turn on the speaker as described in Turning on the product.
- The speaker automatically searches for a connection.
- Open the Bluetooth® settings on your terminal device and wait until "Hama Aqua Jam" appears in the list of Bluetooth ® devices found.
- Select "Hama Aqua Jam" and wait until a tone sounds and the speaker is listed as connected in the Bluetooth ® settings on your terminal device. The LED indicator (2) now lights up steady green.
- Start and end audio playback on your terminal device.
Note – Bluetooth ® password
Some devices require a password to connect to another Bluetooth ® device.
- To connect to the loudspeaker, enter the password 0000 when prompted to enter from your terminal.
Note – Impaired connection
After a successful initial connection of the loudspeaker and the terminal, the connection is made automatically. If the Bluetooth ® connection does not recover automatically, check the following:
- In the Bluetooth ® settings of the terminal, check whether Hama Aqua Jam is connected. If not, repeat the steps under Bluetooth connection.
- Check that the equipment and the speakers are less than 10 meters apart. If not, reduce the distance of the devices.
- Check whether obstacles affect range. If so, position the devices closer together.
Automatic Bluetooth® connection (after successful pairing)
- Make sure that your Bluetooth ® -capable terminal device is on and Bluetooth ® is activated.
- Make sure that your Bluetooth ® -capable terminal device is visible for other Bluetooth ® devices.
- Make sure that the speaker is located within the Bluetooth ® range of max. 10 metres.
- Turn on the speaker as described in Turning on the product.
- A sound signals that the connection has been automatically established. The LED indicator (2) lights up steady green.
- Start and end audio playback on your terminal device.
Hands-free function
You can use the speaker as a hands-free set for your mobile phone. For this function, the mobile phone must be connected to the speaker via Bluetooth®.
- Make sure that your mobile phone is connected to the Bluetooth ® speaker.
- If your mobile phone receives a call, press the on/off button (1) to accept it.
- Press the on/off button (1) again to end the call.
Note – Call quality
- To increase the call quality, make sure that you are near the speaker with your mobile phone during the call.
Battery charging function
Note
- During the charging process, do not under any circumstances expose the product to water.
- Open the closure of the Micro-USB port (4).
- Connect the included USB charging cable to the speaker's Micro-USB port (4).
- Connect the unused plug on the USB cable to an available USB port on your computer or another suitable USB device.
- The LED indicator (2) lights up in red during active charging. When the battery is fully charged, the red LED indicator (2) goes out.
Using the flotation ring
Note
- Carefully seal the Micro-USB port to make sure that the product is water-tight.
- Note that the presence of water may affect the range and tone of the speaker.
- Put the deflated flotation ring over the speaker and position it around the middle.
- Now inflate the flotation ring.
- The speaker can now float in water.
Care and Maintenance
- Make sure that water does not get into the product.
- Rinse off any saltwater residue with fresh water.
- Carefully dry the product after cleaning it or bringing it into contact with water.
Hama GmbH & Co KG
86652 Monheim / Germany
www.hama.com
![]()
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Hama Aqua Jam - Mobile Speaker Manual
Need help?
Do you have a question about the Aqua Jam and is the answer not in the manual?
Questions and answers