272
6-3. Do-it-yourself maintenance
there is no light leaking from the bulb base.
8
Align the tabs and push the light
unit toward the front of the vehicle
to install it.
9
Install the 2 screws and cover.
10
Remove the protective tape.
WARNING
Replacing light bulbs
■
Turn off the lights. Do not attempt to
●
replace the bulb immediately after
turning off the lights. The bulbs
become very hot and may cause
burns.
●
Do not touch the glass portion of the
light bulb with bare hands. When it is
unavoidable to hold the glass portion,
use and hold with a clean dry cloth to
avoid getting moisture and oils on the
bulb. Also, if the bulb is scratched or
dropped, it may blow out or crack.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
Fully install light bulbs and any parts
●
used to secure them. Failure to do so
may result in heat damage, fire, or
water entering the light unit. This may
damage the lights or cause condensa-
tion to build up on the lens.
To prevent damage or fire
■
Make sure bulbs are fully seated and
●
locked.
Check the wattage of the bulb before
●
installing to prevent heat damage.