Lexus RC 350 AWD 2019 Owner's Manual page 137

that blocks the sensor is affixed to the wind-
shield.
Doing so interferes with the sensor detect-
ing the level of ambient light and may cause
the automatic headlight system to malfunc-
tion.
Automatic light off system
■
When the light switch is in
: The headlights and tail lights turn off
30 seconds after the engine switch is
turned to ACCESSORY mode or turned
off and a door is opened and all of the doors
and trunk are closed. (The lights turn off
immediately if
twice after both side doors are closed.)
To turn the lights on again, turn the engine
switch to IGNITION ON mode, or turn the
light switch off once and then back to
or .
If any of the doors or trunk lid is left open,
the lights automatically turn off after 20
minutes.
Light reminder buzzer
■
A buzzer sounds when the engine switch is
turned off or turned to ACCESSORY
mode and the driver's door is opened while
the lights are turned on.
■ Automatic headlight leveling system
The level of the headlights is automatically
adjusted according to the number of pas-
sengers and the loading condition of the
vehicle to ensure that the headlights do not
interfere with other road users.
■ Customization
Some functions can be customized.
(P.339)
NOTICE
■ To prevent battery discharge
Do not leave the lights on longer than
necessary when the engine is not run-
ning.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
4-3. Operating the lights and wipers
, or
on the key is pressed
Turning on the high beam head-
lights
1 With the headlights on, push the
lever away from you to turn on the
high beams.
Pull the lever toward you to the center
position to turn the high beams off.
2 Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
Cornering lights
 When the steering wheel or turn
signal lever is operated while the
headlights are on (low beam) and
the vehicle speed is 19 mph (30
km/h) or lower, a cornering light will
turn on and light up the direction of
movement of the vehicle. The cor-
nering lights are designed to ensure
excellent visibility when making a
turn at an intersection.
 When the shift position is in R while
the headlights are on (low beam),
both cornering lights will turn on.
This is designed to enhance visibility
when parking.
137
4