156
4-5. Using the driving support systems
WARNING
●
If the vehicle cannot be driven in a sta-
ble manner, such as when the vehicle
has been in an accident or is malfunc-
tioning
●
When the vehicle is driven in a sporty
manner or off-road
●
When the tires are not properly
inflated
●
When the tires are very worn
When tires of a size other than speci-
●
fied are installed
When tire chains are installed
●
●
When a compact spare tire or an
emergency tire puncture repair kit is
used
If equipment (snow plow, etc.) that may
●
obstruct the radar sensor or camera
sensor is temporarily installed to the
vehicle
Changing settings of the pre-col-
lision system
Enabling/disabling the pre-colli-
■
sion system
The pre-collision system can be
enabled/disabled on
the multi-information display.
The system is automatically enabled each
time the engine switch is turned to IGNI-
TION ON mode.
If the system is disabled, the PCS warn-
ing light will turn on and a message will
be displayed on the multi-information
display.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
Changing the pre-collision warn-
■
ing timing
The pre-collision warning timing can
be changed on
multi-information display.
The operation timing setting is retained
when the engine switch is turned off.
(P.71) of
1
Far
The warning will begin to operate earlier
than with the default timing.
2
Middle
This is the default setting.
3
Near
The warning will begin to operate later
than with the default timing.
Operational conditions
■
The pre-collision system is enabled and the
(P.71) of the