Burkert 2000 INOX Quick Start Manual
2/2-way angle seat valve
Hide thumbs
Also See for 2000 INOX:
- Operating instructions manual (22 pages) ,
- Operating instructions manual (52 pages)
Subscribe to Our Youtube Channel
Related Manuals for Burkert 2000 INOX
Summary of Contents for Burkert 2000 INOX
- Page 1 Type 2000 INOX 2/2-way angle seat valve 2/2-Wege Schrägsitzventil Vanne à siège incliné 2/2 voies Quickstart English Deutsch Français...
-
Page 2: Table Of Contents
CONTACT ADDRESS ............2 ▶ The quickstart must be available to every user. INTENDED USE ..............3 ▶ The liability and warranty for Type 2000 INOX do not apply if the quickstart instructions are not observed. BASIC SAFETY INSTRUCTIONS .......... 3 The quickstart illustrates the installation and commissioning of TECHNICAL DATA .............. -
Page 3: Intended Use
▶ Observe applicable accident prevention and safety regula- INTENDED USE tions for electrical equipment! Angle seat valve Type 2000 INOX is designed to control the flow- Risk of crushing from moving pneumatic connection! rate of liquid and gaseous media. ▶ When opening and closing the device, do not touch the •... -
Page 4: Technical Data
• When flow inlet over seat, do not use angle seat valve for liquid Conformity media due to the risk of water hammer. The angle seat valve, Type 2000 INOX, conforms to the EC Direc- Risk of burns/risk of fire if used during long-term operation tives according to the EC Declaration of Conformity. - Page 5 Type 2000 INOX Technical data Operating conditions 5.4.2 Pressure ranges WARNING! 5.4.1 Permitted temperatures Ambient temperature: 0 °C ... +60 °C Discharge of medium and danger of bursting. Medium temperature: 0 °C ... +180 °C If the permitted medium or control pressure is exceeded, lines or device may leak and burst.
-
Page 6: Assembly
Type 2000 INOX Assembly ASSEMBLY Devices with welded body: Remove the actuator from the valve body: DANGER! → Clamp the valve body into a holding fixture. Risk of injury from high pressure in the system! NOTE! ▶ Turn off the pressure and vent the lines before loosening Damage to the seat seal or the seat contour! lines or valves. - Page 7 Type 2000 INOX Assembly 6.2.2 Installing actuator on valve housing Pneumatic connection DANGER! WARNING! Risk of explosion if incorrect lubricants used! Risk of injury from unsuitable connection hoses! Unsuitable lubricant may contaminate the medium. In oxygen Hoses which cannot withstand the pressure and temperature applications there is a risk of explosion.
-
Page 8: Start-Up
Type 2000 INOX Start-up DISASSEMBLY START-UP WARNING! DANGER! Risk of injury from discharge of medium and pressure! Risk of injury from improper operation! It is dangerous to remove a device which is under pressure due Improper operation may result in injuries as well as damage to to the sudden release of pressure or discharge of medium. - Page 9 www.burkert.com...
Need help?
Do you have a question about the 2000 INOX and is the answer not in the manual?
Questions and answers