E-Lins H820QO Series User Manual page 89

from 1 to 32.
 HTTP port: set HTTP port, the default port is 80.
 HTTP access from WAN: allow or deny access router web management page from remote side.
 Remote network: Any IP Address, Single IP address, Subnet.
 IP address: fill a remote IP address that can access router web management page.
 Netmask: 24 means net mask 255.255.255.0, 32 means 255.255.255.255, the illegal value is
from 1 to 32.
 RFC1918 filter: reject requests from RFC1918 IPs to public server Ips
3.6.9 Static Routes
 Interface: You can choose the corresponding interface type.
 Target: the destination host IP or network.
 IPv4-Netmask: the destination IP mask.
 IPv4-Gateway: IP address of the next hop.
 Metric: used by router to make routing decisions.
 MTU: maximum transmission unit
 Table: the route table ID, the default value is 254, valid table ID 1-254.
Notice:
Gateway and LAN IP of this router must belong to the same network segment.

If the destination IP address is the one of a host, and then the Netmask must be

255.255.255.255.
If the destination IP address is IP network segment, it must match with the Netmask. For

example, if the destination IP is 10.0.0.0, and the Netmask is 255.0.0.0.
E-Lins Technology Co.,Limited
Tel: +86-755-29230581 E-mail: sales@e-lins.com
H820QO User Manual
www.e-lins.com