Setup - Device Mode - Speco D16RS User Manual

4-4. Setup – DEVICE Mode
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.
Navigate through the menu items using the mouse or the control button on the remote control and change
the value of the menu item.
Item
ALARM OUT
CONTROLLER &
PTZ
SPOT-OUT
SITE
MOTION ZONE
MOTION
Figure 4.4.1. DEVICE Setup Screen
Table 4.4.1. Menu Items in DEVICE Setup Screen
Set the sensor, motion, and video loss for triggering alarm relay
HDD Error and Video Loss can trigger beeping.
(D4RS does not support ALARM OUT.)
Set the PTZ baud rate, protocol, and ID.
(D4RS does not support CONTROLLER & PTZ.)
D4RS/D4WRS: CVBS OUT is switchable as Composite Video Output
or Spot-Out according to the resolution of VIDEO OUTPUT (VGA).
D8RS/D16RS/D8WRS/D16WRS: CVBS1 – Composite Video Output /
CVBS2 – Spot-Out.
Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion detection.
Set the motion sensitivity for the selected channel.
Description
26