Table of Contents
Advertisement
4-4. Setup – DEVICE Mode
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.
Navigate through the menu items or change the settings using the mouse or the remote control.
Item
ALARM OUT
DIGITAL DETERRENT
CONTROLLER & PTZ
SPOT-OUT
SITE
MOTION ZONE
MOTION SENSITIVITY
KEY TONE
REMOTE CONTROL ID
Figure 4.4. DEVICE Setup Screen
Table 4.4. Menu Items in DEVICE Setup Screen
Set the sensor, motion, and video loss for triggering alarm relay
HDD Error and Video Loss can trigger beeping.
Setup schedule and audio recordings for Digital Deterrent.
Set the PTZ baud rate, protocol, and ID.
Display the channels triggered by an event (Refer to 4.4.4)
Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion detection.
Set the motion sensitivity for the selected channel.
Control the motion sensitivity from 1 to 9.
(9 – Highest sensitivity, 1 – Lowest sensitivity)
Enable/disable key tone from front panel usage.
Set the remote control ID.
1. Select ID.
2. Input the remote control ID number.
3. An icon will indicate on the Live Screen if the remote control ID is
synchronized.
The options are from 0 to 99
Description
29
Advertisement
Table of Contents
