Table of Contents
Advertisement
CONTROLS
When towing a trailer
There is no steering intervention when the trailer
socket is in use, for example when operating with
a trailer or bicycle carrier.
Cancellation of the warning
The warning is interrupted in the following situa‐
tions:
▷
Automatically after approximately 3 seconds.
▷
On returning to the correct lane.
▷
If the vehicle is braking heavily.
▷
On indicating.
▷
If Dynamic Stability Control DSC intervenes.
System limits
Safety note
WARNING
The system may not respond at all, or may re‐
spond too late, incorrectly or without justifica‐
tion due to system limitations. There is a dan‐
ger of accidents or damage to property.
Observe the information on the system limits
and intervene actively if necessary.
Functional limitations
The system may have limited functionality in the
following situations, for example:
▷
In thick fog, wet conditions or snow.
▷
When there are missing, worn, poorly visible,
merging/separating or ambiguous lane mark‐
ings; for example, in areas where there are
roadworks.
▷
If lane markings are covered by snow, ice, dirt
or water.
▷
On sharp bends or narrow roads.
▷
If lane markings are not white.
▷
If lane markings are obscured by objects.
▷
If the vehicle is too close to the vehicle ahead.
208
Safety
▷
▷
▷
▷
▷
A Check Control message may be displayed in
the event of limited functionality.
Lane Change Warning
Principle
Lane Change Warning detects vehicles in the
blind spot, or if vehicles are approaching from
behind in the adjacent lane. Different levels of
warning are given in these situations.
General
Operational from a minimum speed, two radar
sensors in the rear bumper monitor the area be‐
hind and next to the vehicle.
The minimum speed is shown in the menu for
the Intelligent Safety Systems.
The system indicates when vehicles are in the
blind spot, arrow 1, or are approaching from the
rear in an adjacent lane, arrow 2.
Online Edition for Part no. xxx - VI/19
If there is sustained glare due to oncoming
light, for example if the sun is low in the sky.
If the field of view of the camera or the wind‐
screen in front of the rear-view mirror is soiled
or covered.
If the camera has overheated due to exces‐
sively high temperatures and has been tem‐
porarily deactivated.
Up to 10 seconds after starting the engine
using the start/stop button.
During the camera calibration process imme‐
diately after vehicle delivery.
Hide quick links:
Advertisement
Table of Contents
