Operational Precautions - Toto WASHLET TCF802C2G Instruction Manual

Safety Precautions
If a water leak should occur, always close the shutoff valve.
When the ambient temperature is likely to drop to 0 °C or lower, prevent
damage to the pipes and hoses due to freezing.
• •
Frozen water pipes could cause the main unit and the pipes to break, resulting in a water leak.
• •
Regulate the room temperature to prevent the pipes and hoses from freezing during cold
months.
• •
Drain the water.
When not using the product for a long time, close the shutoff valve, drain
the water from the main unit and water supply hose, and then flip the power
switch to "OFF".
When using the product again, allow the product to refill with water first. Otherwise, the water in
• •
the tank might become contaminated and cause skin inflammation or other problems.
(Refer to Page 65 for instructions on replenishing the water.)
Leaving the power on may cause fire or heat.
• •
When installing the water filter drain valve, make sure that it is securely
tightened in its proper position.
• •
Failure to securely tighten it may cause a water leak.
If the bowl unit is clogged, flip the power switch to OFF and remove the
clog.
• • If the "Auto flushing" is activated, it would make the wastewater in the bowl unit overflow and
*1
may result in water damage.
• •
Use commercially available tools that are made for unclogging the bowl unit to remove the
clogging.
Push the main unit securely on to the base plate.
• •
After pushing the main unit until a click sound is heard, pull it slightly toward you to make sure
that the product does not detach.
• •
Failure to do so could cause the main unit to come loose resulting in injury.
Make sure of the plus and minus signs on the batteries before inserting
them.
Remove depleted batteries immediately.
When replacing the batteries:
Replace both batteries with new ones.
Use the same brand for both new batteries (any brand available).
Failure to do so may cause the batteries to leak fluid, generate heat, rupture, or ignite.
• •
When the product is supposed not to be used for long time, remove the
batteries from the remote control.
Failure to do so may cause the batteries to leak fluid.
• •
*1 Only applies to toilets with an "Auto flushing" function
8
(Continued)
CAUTION

Operational Precautions

For prevention of malfunctions
Do not block the body sensor or the remote control
transmitter or receiver.
< About the body sensors >
Two types of body sensors are used.
Body sensor A detects changes in heat.
Detection may be difficult when the room temperature
• •
exceeds 30 °C, such as in the summertime.
• •
When sunlight is directly on the sensor area or a heater is
used in the bathroom, the sensor may detect incorrectly
due to the heat, resulting in the automatic operation of
functions such as auto lid opening and closing.
• •
When the bathroom door is open, the sensor may detect
people who pass to the front or side of the toilet.
Body sensor B detects when someone stands in
front of the toilet bowl.
• •
Body sensor B emits an infrared beam as shown in the
figure. When someone moves into the line of this infrared
beam, the sensor detects the person.
* Detection by the sensor may be difficult when the toilet
is used by someone small, such as a child.
Body sensor A Body sensor B
About the built-in seat sensor
When you sit on the toilet seat, the seat sensor turns ON,
enabling you to use various features.
(The deodorizer starts when the
<Detection range>
seat sensor makes a detection.)
Sit so your skin is in direct contact
with the seat sensor. The seat
sensor may not detect properly if
there is a seat cover or clothing.
Water droplets collecting on the
seat sensor may cause the main
4 cm
unit to malfunction. Be sure to
8 cm
wipe off any water droplets on the
12 cm
sensor.
For prevention of damage
Wipe plastic areas
such as the main unit
and remote control
with a soft cloth tightly
Dry cloth or tissue
wrung out with water.
Do not lean against
the toilet lid.
For prevention of malfunctions and failures
Flip the power switch to OFF if there is a risk of lightning.
A toilet seat cover or a toilet lid cover cannot be used.
(The seat sensors may not function properly. Additionally,
the toilet seat and lid may not open or close properly.)
Covers
Do not urinate on the main unit, toilet seat or wand.
(Doing so may cause a failure or discoloration.)
Do not apply strong forces to the control panel of the
remote control.
When using a toilet cleaner to clean the toilet, rinse it
off within 3 minutes and leave the toilet seat and toilet
lid open.
(If vapor from a toilet cleaner enters the main unit, it
may cause a malfunction.)
• •
Wipe off any cleaner that remains on the bowl unit.
Do not use the product with the toilet lid removed.
Do not expose to direct sunlight.
(Doing so may cause changes in color, irregular heated
seat temperature, remote control malfunction or the
product malfunction due to the change in temperature.)
Use radios, etc. away from the product.
(The product could cause interference with the radio
signal.)
If you use a booster seat for infants or a soft highchair,
remove it after use.
(Keeping it installed may prevent some of the
functions from being used.)
Do not apply force to the remote control.
(May cause malfunction.)
• •
To prevent the remote control from being dropped,
set it in the hanger when you are not using it. Be
careful not to expose it to water.
Do not place anything on top of the toilet seat.
Additionally, do not press it by hand.
(Doing so may activate the seat sensor, causing the
floor to get wet if buttons on the remote control are
touched and warm water comes out from the wand.)
About rear cleansing, rear soft cleansing and front cleansing
• •
These functions wash away waste and dirt from a
localized area of your body.
• •
Do not cleanse too much or for too long.
Doing so may wash away normal bacteria, upsetting the
balance of bacteria inside your body.
• •
People who are receiving medical treatment or
therapy in this localized area should consult their
doctor before use.
9