What To Do; If The Water Does Not Flow Due To A Water Service Interruption; If You Cannot Operate With The Remote Control; Freeze Damage Prevention - Toto WASHLET TCF802C2G Instruction Manual

What to Do?

If the water does not flow due to a water service interruption

If you cannot operate with the remote control

If the water does not flow due to a water service interruption
1
Use a bucket to flush water.
If the water level is low after
2
flushing, add more water.
• Prevents odours.
Attention!
• Before starting to work, set "Auto flushing" (Except TCF801CG) to "OFF". (Page 44)
• When water supply is restored, be sure to perform a full flush. (To prevent waste from remaining in the drain pipe.)
If you cannot operate with the remote control
If the low battery warning mark "
on the display screen on the back of the
remote control lights up, please replace the
batteries.
Replacing the batteries
Remove the cover on the left
1
side of the main unit, and flip the
power switch to "OFF".
(Page 13)
Remove the remote control
2
from the hanger.
(Page 12)
Open the battery cover and replace
3
the two AA batteries.
(Page 12)
• The low battery warning mark goes off.
Mount the remote control in the
4
hanger.
Attention!
• "ON" and "OFF" settings of the functions such as the energy saver function may be canceled when the batteries are replaced.
Set them again.
62
Large bucket
Pour strongly,
aiming at the
center of the
bowl unit.
Newspaper, dustcloth, etc.
"
1/5
MENU
Low battery
warning mark
1.MANUAL
CLEANING
Flip the power switch to ON.
5
(Page 13)
• The "Power" LED lights up.
<Power>
6
Reinstall the cover.
(Page 29)

Freeze Damage Prevention

When the ambient temperature is likely to drop to 0 °C or lower, take measures to prevent freezing.
Attention!
• When the ambient temperature is likely to drop to 0 °C or lower, do not use the energy saver feature. (May damage the product.)
• Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 0 °C.
• Before starting to work, set "Auto flushing" (Except TCF801CG) (Page 44) and "Auto open/close" (Page 46) to "OFF".
How to freeze damage prevention
Close the shutoff valve.
(Page 67)
1
• The water supply stops.
CAUTION
Do not remove the water filter
drain valve while the shutoff
valve is open.
(Otherwise, water may leak out.)
2
Press
"Wand CLEAN" button.
(Release the pressure from the water supply
pipe.)
• Water comes out from around the wand.
Remove the cover on the left side
3
of the main unit, and flip the power
switch to "OFF".
(Page 13)
Remove the water filter drain
4
valve.
• Loosen the water filter drain valve with a flat-
head screwdriver and then pull it.
Water filter drain valve
Flat-head screwdriver
After draining the water, install
5
the water filter drain valve.
• Insert the water filter drain valve and use a
flat-head screwdriver to tighten it securely.
Flip the power switch to ON.
6
(Page 13)
• The "Power" LED lights up.
7
Reinstall the cover.
(Page 29)
Set the toilet seat temperature
8
to "High".
(Page 22)
• To maintain the temperature, close the toilet
seat and toilet lid after finishing work.
To use the product again
• The water needs to be resupplied. (Page 65)
63