Advertisement
Instructions: Control Panel LCP 501
5. Synchronising the LCP and the Starter
The DB9 cable can be connected/disconnected from the LCP while the starter
is running.
The first time a LCP is plugged into a starter, the
starter will copy its parameter settings to the LCP.
If the LCP has previously been used with a MCD 500, the operator can select
whether to copy the parameters to the starter, or to copy the MCD 500's
parameter settings into the LCP.
Select the required option using the
buttons. The selected option is surrounded by a
dotted line. Press OK to proceed with the
selection.
If the parameter software version in the LCP is different from the software
version of the starter, only
While the LCP is synchronising, only the
enabled.
and
Starter to Display
MI.17.G1.02 - VLT is a registered Danfoss trademark
New Display Detected
Copy Parameters
Display to Starter
Starter to Display
will be available.
OK and OFF buttons are
Advertisement
