Using The Receiver - Dometic DAB402 Installation And Operating Manual

DAB402
7

Using the receiver

I
NOTE
• When you switch on the car radio for the first time after connecting the DAB402
receiver, it may take a few minutes before the DAB button appears in the main
menu.
• In contrast to conventional radio, in DAB more and more radio and data services
are being broadcast on a frequency. These services are then grouped to form a
so-called ensemble. In some instances, the same radio and data service may be
receivable in different ensembles.
• You should also observe the instructions for the car radio that you wish to use
together with the DAB 402 receiver.
7.1 Selecting DAB playback menu
➤ In the main device, select the menu item [DAB].
7.2 Selecting DAB band
➤ Press
.
✓ The frequency ranges are called up in the following sequence: DAB1 - DAB2 - DAB3.
7.3 Searching for radio services
➤ Press the [Search mode] control panel (fig. 3 8,page 4), to switch between the search
modes:
– [Preset] mode: Actuates the radio services stored in Preset one after the other.
– [Current] mode: Actuates the radio services in the currently selected ensemble one after
the other.
– [All Service] mode: Actuates ensembles one after the other.
– [Manual] mode: Actuates radio services throughout all the ensembles one after the other.
➤ Press
/
7.4 Intro search
➤ Press
.
✓ Stored radio services are played for 10 seconds each, before automatically moving on to the
next radio service.
➤ Press
again.
✓ The current radio service is played permanently.
EN
, to change to the previous/next radio service.
Using the receiver
9