Quick Bios Setup - SOYO Motherboard SY-6ZB Quick Start Manual

Quick BIOS Setup

3
3
This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead,
CPU settings are software configurable with the BIOS [CHIPSET FEATURES SETUP].
After the hardware installation is complete, turn the power switch on, then press the <DEL> key
during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS
SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.
Step 1. Select [LOAD SETUP DEFAULT]
Select the " LOAD SETUP DEFAULT" menu and type " Y" at the prompt to load the BIOS
optimal setup.
Step 2. Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to " Auto" .
Step 3. Select [CHIPSET FEATURES SETUP]
Move the cursor to the [CPU Speed] field to set the CPU frequency.
Available [CPU Speed] settings on your SY-6ZB Motherboard are detailed in the following
table. If you set this field to [Manual], you are then required to fill in the next two consecutive
fields: (1) the [CPU Host Clock], and (2) the [CPU Ratio].
CPU Frequency
233MHz (66 x 3.5)
266MHz (66 x 4.0)
300MHz (66 x 4.5)
333MHz (66 x 5.0)
366MHz (66 x 5.5)
400MHz (66 x 6.0)
433MHz (66 x 6.5)
Note: if you use Bus Frequencies of 75 MHz, make sure that your PCI cards can cope with
the higher PCI clock.
Step 4. Select [SAVE & EXIT SETUP]
Press <Enter> to save the new configuration to the CMOS memory, and continue the boot
sequence.
SY-6ZB Quick Start Guide
Select the working frequency of
your Pentium
350MHz (100 x 3.5)
Celeron
preset values.
400MHz (100 x 4.0)
Note:
450MHz (100 x 4.5)
corresponds to the working
500MHz (100 x 5.0)
frequency of your Pentium
550MHz (100 x 5.5)
Pentium
case the CMOS configuration
600MHz (100 x 6.0)
should be lost.
11
® ®
III, Pentium II,
processor among these
Mark the checkbox that
®
III,
®
processor in
II, Celeron