EMX Industries MVP D-TEK Instruction Manual

Instruction Manual
The MVP D-TEK vehicle loop detector allows for detection of metallic objects entering the field formed
around an induction loop. This detector automatically adjusts to input power from 12 VDC up to 240 VAC
which eliminates the installer's need to match available power to an appropriately rated vehicle detector.
The MVP D-TEK is made from anodized aluminum and all switches have gold plated contacts that are sealed
for protection. It features full loop diagnostic with frequency counter, 10 sensitivity settings, delay mode,
extend mode, fail safe/fail secure mode, automatic sensitivity boost, pulse and presence operating modes
and two output relays.

Cautions and Warnings

This product is an accessory or part of a system. Install the MVP D-TEK according to
instructions from the gate or door operator manufacturer. Comply with all applicable
codes and safety regulations.

Specifications

Power
Draw Current
Loop Frequency
Loop Induction
Surge Protection
Relay Contact Rating
Operating Temperature
Housing Material
Connector
Dimensions (L x W x H)

Ordering Information

MVP D-TEK
•
HAR-11
•
LD-11
•
LD-11B
•
PR-XX
•
TSTL
•
EMX Industries, Inc.
MVP D-TEK_Rev2.0_081319
MVP D-TEK
Multi-Voltage Vehicle Loop Detector
12-60 VDC or 12-240 VAC (48-62 Hz)
19.2 mA
3 settings (low, medium, high)
20-2000 μH (Q factor ≥ 5)
MOV, neon and silicon protection devices
2 DPST 1A @ 30 VDC
-40º to 180ºF (-40º to 82ºC)
Anodized aluminum
11 pin male connector (JEDEC B11-88)
compatible with DIN rail mount socket or wire harness
3.25" (83 mm) x 2.56" (40 mm) x 3.65" (90 mm)
Multi-voltage vehicle loop detector (included)
11 position harness, 3' of wire
11 pin DIN rail socket, black, wide base
11 pin DIN rail socket, black, narrow base
Lite preformed loop (XX – specify size)
Test loop, troubleshooting tool
Tech support: 216-834-0761
technical@emxinc.com
™
TM
1/7