3Com Baseline Switch 2900 Series Getting Started Manual page 59

Loading an application file
To load an application file of the switch, enter 1 in the Boot ROM menu. The system displays the
following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can enter 2 to load the application file.
The procedure of loading an application file is similar to that of loading a Boot ROM file. The difference
lies in that the system displays the prompt of loading the application file rather than the Boot ROM file.
After loading the application file, the switch displays that you should configure the application attribute,
that is, main, backup, or none. Type a specific attribute to complete loading the application file.
Writing flash..................................................................
................Done!
Please input the file attribute (Main/Backup/None) M
Done!
If an application file with a specific attribute already exists when you set a new file with the attribute, the
attribute of the existing file becomes none after the new file becomes effective.
5-17