Page 1
FORERUNNER OF DESKTOP 3D PRINTER Intellectual 3D printer User Manual Only for A7 Thanks for choose JGAURORA A-7 3D printer, please read carefully before use and keep it well. (picture only for reference, check with real product)...
FORERUNNER OF DESKTOP 3D PRINTER {forbidden} 1. Safety Attention { warning } 【 To ensure safety, to avoid any damage or injury, please follow the instructions below】 During machine running, nozzle part can reach to 280℃, platform can reach 110℃, for your safety is forbidden to touch nozzle, platform or printing model during cooling or printing.
FORERUNNER OF DESKTOP 3D PRINTER 3-3 Printing process Unpack the package machine on a stable table Choose “A-7” in software, save the 3d Take out U disk from tool box and files as gcode file into U disk load the software to PC, install it. Press Take out the power cable and Press “All”...
FORERUNNER OF DESKTOP 3D PRINTER 5. Software Instruction 5-1 Software installation Copy the files in U disk to your PC, double click the software installation icon, and enter the software installation interface,the installed process is as the picture shown: Double Press “next(N)”...
Page 10
FORERUNNER OF DESKTOP 3D PRINTER Click the choice,press “Install (I)”...
Page 11
FORERUNNER OF DESKTOP 3D PRINTER Press “Repair (R)”...
Page 12
FORERUNNER OF DESKTOP 3D PRINTER Press “next (N)” Press “finish”...
Page 13
FORERUNNER OF DESKTOP 3D PRINTER Press “next(N)”...
FORERUNNER OF DESKTOP 3D PRINTER 5-2 Software introduction 1)software start Double click enter the software...
Page 15
FORERUNNER OF DESKTOP 3D PRINTER Choose the language you like as above pics shown. 2)add printer choice“A-7”then press“add printer” 3) Load 3d files and slicing. Load model, select the filament type and appropriate print quality, the lower right corner of the software shows "slicing", that is to generate Gcode code;...
Page 16
FORERUNNER OF DESKTOP 3D PRINTER Press “save file” After slicing is completed, the lower right corner of the software shows "save the file”, and save it into the U disk.
FORERUNNER OF DESKTOP 3D PRINTER 5-3 Connect power cable with printer, and power on, machine will in standby state. 5-4 Press ”LEVELING” on the display, extruder will move as the directions of A-B-C-D as pictures shown to level the platform. 5-5 PREHEAT and upload filament Press “PREHEAT”...
Page 18
FORERUNNER OF DESKTOP 3D PRINTER Insert filament into feeding Filament front side hole by anticlockwise face out, put onto direction rack. Press “SETTING” on screen, then press “filament in ”—motor will start feed filament into extruder,until there is filament comes out (As shown in the pic):...
FORERUNNER OF DESKTOP 3D PRINTER 5-6 Print with Gcode in U disk Press “PRINT”—choose the “Gcode”file you want to print —printer will heat up to setting temp in Gcode, when reach the point,the printer will start to print. 5-7 Remove Model...
Page 20
FORERUNNER OF DESKTOP 3D PRINTER Open the door, take out the platform,use shovel to remove model on it. Attention: When using shovel, do not aim to person or yourself, which is to avoid any injury or damage.Meanwhile, pls leveling again to print the next models.
FORERUNNER OF DESKTOP 3D PRINTER 6. Common Question questions cause solutions 1.platform not on the 1,reposition platform Platform can not heat up position; 2、 there is foreign 2,clean foreign on platform bottom object under platform。 Reposition extuder onto magnet Nozzle can not heat up Extruder not in the position hole.