Makita BHR261 Technical Information page 14

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-7. Impact bolt in Tool holder complete (BHR261)/ Tool holder guide complete (BHR261T)
DISASSEMBLING
(1) When Striker is left in Tool holder (guide) complete, push Striker out of Tool holder (guide) complete by inserting 1R281
from the top end and striking the 1R281 with plastic hammer.
(2) Remove Tool holder (guide) section as mentioned in the clause of [3]-5.
(3) Remove Ring spring 28 from Tool holder (guide) complete and disassemble Impact bolt section. (Figs. 39 to 42)
Fig. 39
clearance of Ring spring 28
Fig. 40
Tap Ring spring 28 from the two holes alternately to push
downward.
Fig. 41
Tool holder (guide) complete
Ring spring 28
Ring spring 28 can be pulled off from Tool
holder (guide) complete when completely
remove from the groove.
Note: Be sure to replace Ring spring 28
when assembling Tool holder (guide)
section.
Ring spring 28
Note: When the clearance of Ring spring 28
is in the hole, slide the clearance to
the blind side using a slotted screwdriver.
[Cap 35 side]
Tool holder complete
Ring spring 28
[Inner housing complete side]
Fig. 42
Vise
Tool holder
(guide) complete
Disassemble Impact bolt
section by striking Tool
holder (guide) complete
against workbench.
P 14/ 21
1R038
Impact bolt section
Sleeve 9
Impact bolt
Ring 10
Cushion ring 13
O ring case with
O ring 9 fit inside