Advertisement
PRO-TEST OPERATORS HANDBOOK
3.
Plug Power Supply into back of transducer housing then plug mains lead into Power Supply.
If a mains plug is not fitted, wire as follows :
BROWN-LIVE
WARNING! It is important that live, neutral and earth are all connected
between the Pro-Test and mains power supply. If no earth is available (2 wire
mains power supply) it is recommended that a separate earth is connected
between the transducer housing (the bottom right hand fixing screw in the
corner of the back panel is ideal) and a suitable earth.
4.
If power supply has an ON/OFF fitted, switch to 'ON'.
5.
Wait 2 seconds for initialisation and allow 5 minutes for the instrument to warm up and stabilise,
then press 'ZERO'.
6.
Select required units of measurement. Pressing the 'SELECT UNITS' button once will step onto
the next available unit of measurement.
7.
Select mode of measurement required. Pressing the 'MODE' button once will step onto the next
available.
BENDING BEAM WRENCHES, DIAL TYPE WRENCHES & TORQUE SCREWDRIVERS:- _______
INSTRUMENT MODE :
PRESET (CLICK) WRENCHES & TORQUE SCREWDRIVERS:- ____________________________
INSTRUMENT MODE :
8.
Fit adapter supplied to hex drive of transducer, then tool to be tested to square of adapter.
9.
Operate tool to be tested.
10. If the Pro-Test is loaded in a 'MANUAL RESET' mode, press 'RESET' to clear the display after
the torque has been removed. If an 'AUTO RESET' mode is used, the display will clear
automatically after the torque has been removed.
NOTE:- If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment could be impaired.
BLUE-NEUTRAL
Peak memory with manual reset or
Peak memory with auto reset
First peak memory with manual reset or
First peak memory with auto reset
GREEN / YELLOW-EARTH
PAGE 3 OF 10
ISSUE 4
AUGUST 1998
Hide quick links:
Advertisement
