Technical Data - S+S Regeltechnik Thermasreg RTR-E-UP Series Operating Instructions, Mounting & Installation

G
®
THERMASREG
Electronic single-room controllers ⁄ "clock thermostats with week program THERMASREG
sensor for in-wall installation suitable for temperature monitoring and control, for activating any kind of heating system and valves (closed when
currentless), as room temperature controller, room thermostat, floor temperature controller, or clock controller, e. g. for electric floor direct
heating systems, for bathrooms, for night storage, wall, ceiling and gas heating systems.

TECHNICAL DATA

Power supply:
Temperature sensor:
Control range:
Output:
Switching capacity:
Switching current:
(Contact load)
Safety:
Operating difference:
Enclosure:
Dimensions:
Electrical connection:
Temperature range limitation:
Installation:
Protection class:
Protection type:
Standards:
RTR -E - UP
230 V AC, 50 Hz
NTC according to DIN 44574, sensor extension up to max. 50 m,
with double insulation according to EN 60730-2-1
see table
+15...+30 °C for room temperature controllers
+10...+60 °C for floor temperature controllers
+15...+30 °C and
+20...+60 °C for combined controllers
1x normally open contact (single ended)
3.6 kW
16 A (ohmic load)
with sensor breakage and sensor short circuit protection
(in case of sensor breakage or sensor short circuit heating is switched of)
approx. 0.6 K
plastic, colour pure white (similar RAL 9010)
80 x 80 x16 mm
2 via terminal screws on circuit board
0.14 - 2.5 mm
in the turning knob
in in-wall flush box Ø = 55 mm
II (according to EN 60 730)
IP 30 (according to EN 60 529)
CE conformity,
electromagnetic compatibility according to EN 61 326,
EMC directive 2014 ⁄ 30 ⁄ EU,
low-voltage directive 2014 ⁄ 35 ⁄ EU
® RTR-E-UP with internal sensor or 4-meter remote
10
Rev. 2017 - V11 GB