California Energy Commission Battery Charging Testing Instructions - VTech DS6161 User Manual

If this product is equipped with a corded
or cordless handset, it is hearing aid
compatible.
If this product has memory dialing locations,
you may choose to store emergency
telephone numbers (e.g., police, fire,
medical) in these locations. If you do store
or test emergency numbers, please:
Remain on the line and briefly explain the
reason for the call before hanging up.
Perform such activities in off-peak hours,
such as early morning or late evening.
Industry Canada
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada's licence-exempt
RSS(s).
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Privacy of communications may not be
ensured when using this telephone.
The term ''IC:'' before the certification/
registration number only signifies that the
Industry Canada technical specifications
were met.
The Ringer Equivalence Number (REN) for
this terminal equipment is 1.0. The REN
indicates the maximum number of devices
allowed to be connected to a telephone
interface. The termination of an interface
may consist of any combination of devices
subject only to the requirement that the
sum of the RENs of all the devices not
exceed five.
This product meets the applicable
Innovation, Science and Economic
Development Canada technical
specifications.
California Energy Commission
battery charging testing
instructions
This telephone is set up to comply with the
energy-conserving standards right out of the
box. These instructions are intended for California
Energy Commission (CEC) compliance testing
only. When the CEC battery charging testing
mode is activated, all telephone functions, except
battery charging, will be disabled.
To activate the CEC battery charging testing
mode:
1. Unplug the telephone base power adapter
from the power outlet. Make sure all handsets
are plugged with charged batteries before
proceeding.
2. While you press and hold FIND HS , plug
the telephone base power adapter back to
the power outlet.
3. After about 20 seconds, when the IN USE
light starts flashing, release FIND HS and
then press it again within 2 seconds.
The process takes up to one minute to
complete. When the phone successfully enters
the CEC battery charging testing mode, the IN
USE light turns off and all handsets display To
register HS... and ...see manual alternately.
• When the phone fails to enter this mode, repeat
Step 1 through Step 3 above. The telephone base
will be powered up as normal if you fail to press
FIND HS within 2 seconds in Step 3.
To deactivate the CEC battery charging testing
mode:
1. Unplug the telephone base power adapter
from the power outlet, and then plug it back
in. Then the telephone base is powered up as
normal.
2. Place the handset in the telephone base
to register it back. The handset displays
Registering....
• You hear a beep when the registration process
completes. The registration process takes about
90 seconds to complete.
32