Eaton Aeroquip Rynglok Fitting System Installation Manual page 2

Enlarged version

Rynglok Fitting System Installation Guide

1.0 Initial Preparation .................................................................................... 3

1.1 Cutting Tubes

1.2 Tube End Preparation

1.2.1 Painted Tube End Preparation

1.3 Pre-applied Tube End Marking

1.4 Marking Gauge Positioning

2.0 Fitting Installation ................................................................................... 4

2.1

Positioning Mark

2.1.1 End Fittings

3.0 Fitting Assembly ..................................................................................... 5

3.1 Assembly Tool Selection

3.1.1 Assembly Tool/Fitting Compatibility

3.2 Assembly Tool Pressure Connection

3.3 Tool Installation

3.4 Tool Pressure

3.4.1 Pressure Level

4.0 Assembled Fitting Inspection ................................................................. 6

4.1 Ring Advancement Inspection

4.1.1 Insertion Inspection Mark Position

4.2 Shared Insertion - Unions

4.2.1 Over Insertion Condition - Fittings Other Than Unions

5.0 Tubing Repair With Rynglok Unions ........................................................ 7

5.1 Single Union Repair

5.1.1 Cutting Through Center Of Defect

5.1.2 Cutting Out Defect

5.2 Two Union Repair

6.0 Special Considerations ........................................................................... 8

6.1 Using The "Reversed Tool"

6.2 Special Considerations When Using The "Reversed Tool"

6.3 Special Considerations When Using The -20 and -24 Tools

7 .0 Tube Cut Dimensions ............................................................................. 9

7 .1 Female Arcseal™ Fitting

7 .2 Female Flareless Fitting

7 .3 Female Flared Fitting

8.0 Fitting Selection Chart ........................................................................10 – 11

EATON Aerospace Group TF100-67A March 2013