Installation And Technical Drawings - NRG Systems Hybrid XT Vane Product Manual

NRG Product Manual
Hybrid XT Vane

INSTALLATION AND TECHNICAL DRAWINGS

Mounting Mast Orientation
Refer to the technical drawing for details on mounting mast design. Orient the cross-holes in the top of the mounting
mast such that they are lined up parallel to the turbine nacelle centerline.
Nacelle centerline
Prepare Shield
Based on your decision about the cable shield connection scheme (see previous section and Appendix A), cut off or
attach the shield to the mounting mast. If you choose to cut the shield wire, make sure to cut it off short enough to
avoid touching the mounting mast or bolt.
HybridXT_Vane_Manual
Rev 13.0
Align cross-holes parallel to nacelle centerline.
Cross-holes
Typical
mounting
mast
IF cutting shield wire, cut close to
connector base as shown.
support@nrgsystems.com | Page 11
7 February 2017