Advertisement
Testing Your Alarm System
To test your alarm system first you must call Emergency 24 at 1-800-424-3624 the operator will
answer and you will tell them your six (6) digit account number and then your four (4) digit code you
use to disarm your alarm system. Once you tell them this data tell them you would like to put the system
on test for 2 hours. Once your system is on test turn your system on for away and open and close the
delay door and wait for the delay timer to run out and your system to arm. Once the system is armed
open and close of the doors/windows, walk in front of motion sensors, and use something firm and hit
the GLASSBREAKS not the glass but the device. This will put your system into an alarm. Once you
have activated every device go to the keypad and disarm the system ONCE and only ONCE for now.
After you have disarmed the system on the keypad press the * button to view which devices went into
alarm. (Reference your zone list for this) If any devices did not show up on the keypad repeat the
previous steps but only activate the devices that did not show up the first time. (If they do not show
again call R.J. Beck for service) once you get all of your devices activated and referenced disarm your
system again and then call Emergency 24 back and give them the information again and then ask if they
have received any signals recently. If they receive all of the signals and all of your devices showed up on
the keypad tell them to take the system off of test. If they do not receive any signals call R.J. Beck for
service.
Advertisement
