Advertisement
Clearing the Keypad
Whenever an alarm goes off silent or audible you will have to clear the keypad. This is a
two-step process, if you have an audible alarm (siren is going off) the keypad will say ALARM the zone
number and a description of the zone. Enter your four (4) digit code followed by the number 1 (_ _ _ _
+1) doing this once will silence the alarm but will not clear the keypad. To clear the keypad so you can
arm the system again you have to reenter your 4 digit code followed by the number 1 (_ _ _ _+ 1)
Follow these same steps for a silent alarm. A silent alarm is when the keypad says NOT READY TO
ARM HIT * FOR FAULTS and you hit the * button and nothing happens.
Misc. Information
Chime Mode
This security panel has a number of features. One of the most popular is known as Chime mode.
While disarmed and with chime mode activated, whenever a door is opened the keypad will chime.
Chime mode can be turned on and off whenever you would like. All you have to do is type in your 4
digit code followed by the number 9 (_ _ _ _+ 9) this will turn chime on and off. When chime is on the
keypad will read "DISARMED CHIME READY TO ARM" when chime is off it will read
"DISARMED READY TO ARM"
Adding Codes
Another feature is you can have 48 different codes programmed into your alarm system and are
able to add and delete them as you like. (Be sure to make a list of all the codes and contact R.J. Beck
419-668-3056 if you change codes so your code is valid with Emergency24) To add a user code enter
your 4 digit MASTER CODE (this is the main code that you use) followed by the number 8 then the
user number (two digits) and finally the new 4 digit code you want to enter. (Master_ _ _ _ + 8+ user no.
+ New _ _ _ _) The user number is always two digits (i.e. 02, 03, 15, 40) the master code user number is
02 any codes added after will begin at 03 and then to 04 and so on until all desired codes have been
entered.
Deleting Codes
To delete a code enter your 4 digit master code followed by the number 8, then the user number
you want deleted and finally enter #0 (_ _ _ _+ 8 + user no. + # + 0)
Advertisement
