Hamilton Jet HJ212 Installation And Service Manual page 122

Appendix
Painted Gloss Bores, Stainless Steel Bushes
Loctite Colour
680 GREEN
Painted Gloss Bores, LG2 Bushes
Loctite Colour
680 GREEN
Studs M8 and Larger
Loctite Colour
263 RED
Primer, Activator, Accelerator
Type Drying Time
Primer 7471 30-70 Seconds
Bushes, sleeves, composite bush assemblies (extra high strength retaining).
Primer is used in all retaining applications.
Do not apply primer to painted bore.
1 - Apply primer to outside of outside of bush and allow to dry.
2 - Apply Loctite to whole surface of bore and outside of bush before fitting
bush.
 There are to be no dry areas between bush and bore.
Rotate bush when fitting to distribute the Loctite evenly.
Primer, Activator, Accelerator
Type Drying Time
n/a n/a
Bushes, sleeves, composite bush assemblies (extra high strength retaining).
1 - Apply Loctite to whole surface of bore and outside of bush before fitting
bush.
There are to be no dry areas between bush and bore.

Rotate bush when fitting to distribute the Loctite evenly.
Primer, Activator, Accelerator Loctite Cure Speed
Type Drying Time
Primer 7649 30-70 Sec
(Optional) n/a
Studs (high strength locking).
Primer is used to improve cure reliability and reduce cure time.
1 - Apply optional primer to the thread of the stud and allow to dry.
2 - Apply several drops of thread locker down the sides of female thread.
3 - Apply Loctite to the thread engagement area of the stud in sufficient
quantity to fill all engaged threads.
Assemble the stud to specifications.
Loctite Cure Speed without Primer
Activator, Accelerator
Partial
5 Min
Loctite Cure Speed without Primer
Activator, Accelerator
Partial
5 Min
Partial
With Primer 10 Min
Without Primer 20 Min
10-6
Installation and Service Manual
Full
4-6 Hrs
Full
4-6 Hrs
Full
2 Hrs
6 Hrs