Grizzly T10096 Instructions Manual page 8

Lubrication
Always disconnect power
to the lathe before per-
forming
Failure to do this may
result in serious person-
al injury.
Using an oil can with the same oil you used on
your lathe ball oilers, apply liberal amounts of oil
to the three ball oilers, the pivot pin, and the dove-
tail surface shown in Figure
Figure 24. Lubrication locations.
-8-
maintenance.
24
.
Using an oil can with the same oil you use on your
lathe ball oilers, apply oil on the knob threads and
the dovetail ways shown in Figure
Figure 25. Lubrication locations.
Cleaning
Vacuum excess metal chips and wipe off the
remaining metal, coolant, and oils with a dry
cloth.
If any coolant sludge has built up, use mineral
spirits to remove, and then relubricate with the
same oil you use on your lathe or use G96
Treatment, SLIPIT , or Boeshield
®
surface rust.
T10096 Taper Attachment
25
.
Gun
®
T-9 to prevent
®