Advertisement
7.
Use a 4mm hex wrench to loosen slide block
set screw (see Figure 7).
Figure 7. Slide block removal.
8.
Lift out slide block without losing brass anti-
score plug (see Figure 8).
Figure 8. Slide block brass anti-score plug.
9.
Apply a dab of multipurpose grease to brass
plug to prevent it from falling out when han-
dling slide block.
Note: This brass plug prevents the set screw
from scoring the main pivot pin when the
taper attachment is being used.
T10096 Taper Attachment
Brass
Anti-Score
Plug
10. Use a 5mm hex wrench to remove two cap
screws and slide block end cap (see Figure
9).
Figure 9. Slide block end-cap removal.
11. Oil and install bearings and races onto lead-
screw in order shown in Figure 10. Finger-
tighten first 17mm hex nut onto leadscrew
until bearings are slightly preloaded, then
lock in place with second nut. Make sure slide
block end cap has no lash or end play.
Slide Block
End Cap
Bearing
Cap
Figure 10. Slide block end-cap installation.
Inner
Bearings
Hex Nuts
-3-
Advertisement
