Advertisement
12. Use a 5mm hex wrench to secure slide block
to end cap with two previously removed cap
screws (see Figure 11).
Note: Make sure the top of both slide and
end cap surfaces are flush with one another
after tightening the cap screws (see Figure 11).
Slide
Block
Figure 11. Slide block installation.
Tip: To make the following steps easier,
remove the taper attachment body from the
dovetail slide.
13. Make sure brass plug is still inside slide block.
14. With help of assistant, raise and align taper
attachment body, so slide block drops into
slot evenly (see Figure 12).
15. Use
⁄
" or 10mm transfer punch to locate
25
64
holes to be drilled and tapped for mounting
attachment (see Figure 12). Once holes
have been marked, drill with (Q) drill bit and
tap them M10 x 1.5.
Figure 12. Taper attachment installation.
-4-
16. Reconnect taper attachment body to slide.
17. Use a 4mm hex wrench to snug slide block
End Cap
18. Liberally apply drops of oil at locations shown
Raise and align taper attachment assembly,
so pivot pin slides into pin bore in slide block.
Use 8mm hex wrench to secure taper attach-
ment to carriage face.
set screw so brass plug is slightly preloaded
against pivot pin (see Figure 13).
Figure 13. Pin adjustment.
in Figure 14.
Figure 14. Setup lubrication locations.
T10096 Taper Attachment
Pivot Pin
Advertisement
