MSA Advantage 200LS Operator's Manual

MSA Advantage 200LS Operator's Manual

Respirator facepiece
Hide thumbs Also See for Advantage 200LS:

Advertisement

Quick Links

Instructions

This booklet, including the warnings and cautions inside, must be
carefully read and followed by all persons who use or maintain this
product, including those who have any responsibility involving its
selection, application, service, or repair. This respirator will per-
form as designed only if used and maintained according to the
instructions. Otherwise, it could fail to perform as designed and
persons who rely on this product could sustain serious personal
injury or death.
See inside for Instructions, Warnings, and Limitations for Advantage
200LS Respirators.
Niosh Approval Information is included as a supplement (P/N
10021588) to these instructions.
For additional information, call 1-800-MSA-2222 during regular working
hours.
Patented MultiFlex
®
U.S. Patent No. 5,592,937
TAL 508 (L) Rev. 9
System
© MSA 2005
Prnt. Spec. 10000008114(B)
Mat. 815908
Doc. 815908

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Advantage 200LS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MSA Advantage 200LS

  • Page 1 See inside for Instructions, Warnings, and Limitations for Advantage 200LS Respirators. NIOSH approval information is included as a supplement (P/N 10021588) to these instructions. For additional information, call 1-800-MSA-2222 during regular working hours. Patented MultiFlex ® System U.S.
  • Page 2 INTRODUCTION NIOSH APPROVAL INFORMATION N- Never substitute, modify, add, or omit parts. Use only exact replacement parts Protection in the configuration as specified by the P100—Particulate Filter (99.97% filter effi- manufacturer. ciency level) effective against all particulate O- Refer to User’s Instructions and/or main- aerosols.
  • Page 3 INTRODUCTION manipulation of the respirator, car- 5. Leave area immediately if: tridges, facepiece, or the indicator. If A.Breathing becomes difficult. you cannot readily see the indicator, do B.Dizziness or other distress occurs. not wear the respirator. The ESLI band C.You taste or smell contaminant. around the side of each Mersorb- D.You experience nose or throat irrita- P100/Mersorb cartridge consists of...
  • Page 4 EXPOSURE LIMITS stances having poor warning proper- ties, over exposure can occur without A listing of acceptable exposure limits from user awareness. Take appropriate pre- the following sources is provided in MSA’s Response ® Respirator Selector: cautions to prevent overexposure, which may include an earlier cartridge —...
  • Page 5 1. Neck strap/Headband: Check to see that ry for protection against all contaminants the headband and neck strap still have present. See MSA’s Response Respirator their elasticity. Inspect for breaks or tears Selector for additional information. and make sure all adjusters are in place and working properly.
  • Page 6 ADJUST THE STRAPS OBTAIN A COMFORTABLE FIT DONNING THE RESPIRATOR TEST FOR TIGHTNESS To don the Advantage 200LS Respirator, fol- low the outlined steps: 1. Loosen all the straps by pulling the tab back on the latch with your finger.
  • Page 7 If the facepiece is to be cleaned, remove the able. cartridges. The facepiece should be cleaned 5. Respirator has passed a tightness and disinfected after every use with MSA test. (See Test for Tightness.) non-sudsing Confidence Plus® Cleaner (P/N 6. Filters/Cartridges do not need to be 10009971).
  • Page 8 DESCRIPTION MAINTENANCE This respirator must be kept in good condi- tion to function properly. When any respira- tor shows evidence of excessive wear or damage, it must be replaced immediately. Refer to the Preparations for Use section for proper inspection of the respirator. This res- pirator, when not in use, should be stored in a clean, dry location, such as its storage bag.

Table of Contents