Table of Contents
Advertisement
2.
Remove the 2 cotter pins from the control valve
spool.
3.
Mount the auxiliary control lever to the valve
spool with the cotter pins.
4.
Install the control lever cover.
Safety Latch
Only remove the safety latch when operating the
combination deck
(Figure
Traction Unit PTO
The vacuum fan on the machine will run as soon
as the PTO is engaged
combination decks are engaged by the hydraulic
controls on the machine.
Important:
Always engage the traction unit PTO
gently at a low engine speed. Sudden engagement
of the traction unit PTO at a high engine speed will
likely cause damage to the drive line components.
3).
(Figure
3). The finger and
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
CAUTION
If you leave the key in the traction unit ignition
switch, someone could accidently start the
engine and seriously injure you or other
bystanders.
Remove the key from the traction unit ignition
before you do any maintenance.
Before Operation
Before Operation Safety
General Safety
•
Do not allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Know how to stop the machine and shut off the
engine quickly.
•
Do not operate the machine without all guards
and other safety protective devices in place and
functioning properly on the machine.
•
Ensure that all hydraulic line connectors are tight,
and all hydraulic hoses and lines are in good
condition before applying pressure to the system.
•
Before operating, always inspect the machine to
ensure that the flail knives are in good working
condition. Replace worn or damaged knives.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
strike.
•
Ensure that your traction unit is suitable for use
with an implement of this weight by checking with
your traction unit supplier or manufacturer.
•
The traction unit must have the proper wheel base
and tread width and be equipped with a roll bar
and seat belt to operate safely on hilly terrain.
The normal operating speed is 10 km/h (6 mph)
but will vary with terrain and debris being picked
up. The maximum transport speed is 24 km/h (15
mph) with slower speeds required on hilly terrain.
Refer to the traction unit Operator's Manual for
information or traction unit service agency if you
have any questions on safe operation.
9
Advertisement
Table of Contents
