Greasing The Machine; Product Overview; Controls - Toro Versa Vac 07053 Operator's Manual

3
Connecting the PTO Shaft
No Parts Required
Procedure
Connect the PTO shaft; refer to
Shaft (page 12)
4

Greasing the Machine

No Parts Required
Procedure
Grease the machine; refer to
(page 17)
Connecting the PTO
Lubricating the Machine

Product Overview

Controls

1. Brush control
2. Deck lift control
3. Trailer lift control
Trailer Lift Control
Used to dump the trailer box
position raises the box and opens the door, and the
down position lowers the box and closes the door.
Deck Lift Control
Used to raise and lower the primary deck
3). The up position raises the deck, and the down
position lowers the deck.
Brush Control
Used to operate the rotating finger deck (sold
separately). The up position starts the deck, and the
down position stops the deck
Auxiliary Control
Used to operate the combination deck (sold
separately). The up position starts the deck, and the
down position stops the deck
Important:
The auxiliary control lever is shipped
loose to prevent accidental engagement of the
unused hydraulic circuit. Do not install or operate
the auxiliary control lever unless the combination
deck is installed.
To install the auxiliary control lever, complete the
following procedure:
1. Remove the control lever cover.
8
Figure 3
4. Auxiliary control
5. Safety latch
(Figure 3). The up
(Figure
(Figure 3).
(Figure 3).
g027357