5.
Adjust the machine hitch clevis to the same level
as the traction unit hitch as follows:
A.
Remove the bolts and locknuts that secure
the hitch clevis
frame.
Figure 6
1. Clevis hitch
B.
Raise or lower the hitch clevis to the position
approximately level with the traction unit
hitch.
C.
Secure it with the bolts and locknuts that
were previously removed.
6.
Connect the traction unit hitch to the machine
clevis hitch with the hitch pin and clevis.
7.
Remove the jack pin, rotate the jack upward to
the storage position.
(Figure
6) to the machine
Connecting the PTO Shaft
1.
Connect the PTO shaft to the machine impeller
input shaft.
2.
Connect the PTO shaft to the rear traction unit
PTO shaft.
3.
Slide the PTO shaft forward as far as it will go.
4.
Press the pin to secure the PTO shaft in place.
Note:
Slide the PTO shaft back and forth to
ensure that it is properly locked.
5.
Connect the shield safety chain to the traction
unit
(Figure
Note:
Ensure that the chain remains slack
when you turn the traction unit.
g027353
1. Safety chain
CAUTION
If the shield chains are not connected,
the shields could rotate during operation
and cause bodily injury.
Keep all PTO shields in place and
connect the shield chain to the traction
unit or PTO shields.
12
7).
Figure 7
g027355