Connecting The Upper Link - Toro 44536 Operator's Manual

2
Connecting the Lower Link
Arms
No Parts Required
Procedure
1. Position the blower on a flat, level surface and
disengage the PTO.
2. Back the tractor squarely up to the blower until
the lower link arms are aligned with the hitch
pins.
3. Engage the parking brake, shut off the traction
unit engine, and remove the key from the
ignition.
Note:
Wait for the traction unit engine and
all moving parts to stop before leaving the
operator's seat.
4. Insert the right and left, lower link arms onto the
hitch pins (Figure
1. Lower link
5. Secure the lower link arms to the hitch pins with
the lynch pins (Figure
3).
Figure 3
2. Lynch pin
3).
3

Connecting the Upper Link

No Parts Required
Procedure
1. Connect the upper link to the holes in the blower
bracket and secure it with a clevis pin and lynch
pin (Figure
1. Upper link
2. Rotate the adjusting link to tighten the link.
Note:
Do not overtighten to raise the back end
of the blower off the ground.
3. Tighten the locknut to secure the upper link into
position.
g011991
6
4).
Figure 4
g011992