Mazda CX-9 2007 Service Highlights page 441

SECURITY AND LOCKS [ADVANCED KEYLESS SYSTEM]
PID/data monitor function
• The PID/data monitor function is used for optionally selecting input/output signal monitor items preset in the
keyless control module and reading them out in real-time.
• Use the Mazda Modular Diagnostic System (M-MDS) to read the PID/data monitor.
PID/data monitor table
PID name
(definition)
DTC_CNT Number of continuous DTCs
RPM Engine speed
VSS Vehicle speed
VPWR Supply voltage
NUMCARD Number of programmed card keys
*
Number of programmed key ID numbers
NUMKEY
DRSW_D Door switch (driver's door)
DRSW_ALL Door switch (except driver's door)
REQ_SW_P Request switch (right side door)
REQ_SW_D Request switch (left side door)
REQ_SW_BK Request switch (liftgate)
LOCK_SW_D Door lock-link switch (driver's side)
IMMOBI Immobilizer system equipped or not
TR/LG_SW Trunk compartment light switch
IG_KEY_IN Key reminder switch
IG_SW_ST Ignition switch (Push switch)
BUZZER Keyless beeper
PWR_IG1 Power supply (IG1)
PWR_ACC Power supply (ACC)
* : Vehicles with immobilizer system
Simulation Function
• The simulation function is used for optionally selecting simulation items of output parts preset in the keyless
control module, and to operate them regardless of control.
ACTIVE COMMAND MODE TABLE
Command
name
BZR_OUT Keyless beeper
BZR_INN Interior buzzer (Instrument cluster)
LNP_RED Keyless warning light (red)
LNP_GREEN Keyless indicator light (green)
DR_LOCK All doors lock
DR_UNLOCK All doors unlock
End Of Sie
NG: IMMOBILIZER SYSTEM
Data contents
Output part name
Unit/
Terminal
Operation
− −
RPM 3W, 3X
KPH 3W, 3X
V 2A
− −
− −
CLOSE/
3Q
OPEN
CLOSE/
3Q
OPEN
On/Off 3K
On/Off 3I
On/Off 3M
On/Off 3N
−
*
On /Off
CLOSE/
OPEN
Key-In/Key-
3F
Out
Pushed/Not
3E
Pushed
On/Off 2K
On/Off 2C
On/Off 2E
Unit/
Terminal
Operation
On/Off 2K
On/Off 3W, 3X
On/Off 3W, 3X
On/Off 3W, 3X
Off/Lock 3Q
Off/Unlock 3Q
09-14A–23
09-14A