Set Sensor Range; Snapshot - Data Harvest EASYSENSE Q Advanced Manual

Set sensor range

Some Smart Q sensors have multiple ranges e.g. sound can be in decibels (dBA) or milli volts (mV).
The range of a sensor can be altered whilst in Meter mode.
Whilst in Meter use the blue up/down
G G
until the pointer is pointing at the appropriate sensor.
Press the green
G G
Note: If there isn't a choice of range available for the selected sensor then pressing enter will have no effect.
An asterisk * will indicate the present range selected. Use the blue
G G
up/down buttons to scroll the list until the pointer is pointing at the
required range.
Press the green
G G

Snapshot

Snapshot mode enables you to capture sensor readings every time the green
rather than at a regular time intervals. The readings are stored as a data set in EASYSENSE Q
Advanced's memory.
Connect the sensors. If the display is turned off, press any button to wake up EASYSENSE Q
G G
Advanced.
Use the blue up/down
G G
pointer is pointing at Snapshot.
Press the green
G G
Each data sample can be given a name/number e.g. the location at which the sample was taken.
G G
Use the blue up/down
button to view the ranges available.
button to select the range and return to Meter.
buttons to scroll through the menu until the
button to select Snapshot.
buttons to select from either yes or no for this option.
buttons to scroll through the list
10
button is pressed,